And it definitely will be your sidekick for when you need to clean your shotgun be it at home, at the range, or while you are out hunting.
He also added the cleaning rods were easy to assemble and super durable as well. One user said that he had just enough cleaning pads to make sure that his shotgun was clean and ready for the next hunting adventure.
For one, they said that they had all the accessories and cleaning supplies they needed to ensure that their Remington 870s were clean from the inside and out. In each case, always do the cleaning after unloading, turning on the safety, and practice the 10 firearms safety commandments.Ī lot of recent buyers were happy with the kit and for a few good reasons. When it comes to safety, shotguns are not much different from handguns and rifles. The hammer should not be cocked during the cleaning operation either. If it is not already unloaded, push upwards on the action bar lock, pull the fore-end slowly rearwards until the shell can be removed from the ejection port, then repeat until the gun is empty.Ĭheck the chamber and magazine with both touch and sight to make sure there are no shells in the firearm.Įnsure that the safety is on since pulling the trigger during the cleaning steps could cause injury or damage the trigger group. Follow the 10 Commandments of Firearm Safety at all times.īe sure to always keep the muzzle pointed in a safe direction when working on the gun.īefore starting, check that your firearm is unloaded. Safety should always be the first consideration when cleaning a shotgun.
#Remington gun cleaning Patch
Remove patch from jag, then pull the rod and jag back towards you.(Note: do not pull the patch back through the barrel towards you as it may get stuck.)Repeat 2 times. Push the patched jag through the entire length of the barrel away from you. Place corner of dry cotton patch over the tip of the jag.
Place corner of cotton patch over the tip of jag. Insert a bore guide to protect rifling from the rod and prevent solvent/fouling residue from leaking into the action.Wrap cotton patch around chamber brush to remove excess cleaner and oil.Clean powder residue from the chamber, neck and shoulder of the barrel. Wrap cotton patch around chamber brush and soak with Remington 40-X Bore Cleaner.Follow up with dry patches or mop to remove Rem Oil and residue. Wrap cotton patch around chamber brush and soak with Rem Oil (liquid or spray aerosol) or Rem Oil Pro3 (liquid or spray aerosol.) Clean loose dirt and grime from the chamber, neck and shoulder area of the barrel.
0 kommentar(er)
